Tru-gage Model 224-13 LMS
This machine is a manually loaded and operated wheel inspection machine using laser measuring technology. This machine can inspect the following features of a wheel.

Features include:

• Runout of the inner and outer tire bead seats
• Diameter of the inner and outer tire bead seats.
• 1st-4th Harmonic measurements.
• Low spot angle and amplitude.
• Wheel width & Offset
• Manual low spot marking by applying stickers by hand

Click here to download PDF document with more information.
You may download the free Adobe PDF reader here

Tru-gage  Model 224-13 LMS PCD

This Machine is a manually loaded and Operated wheel inspection Machine that can replace a CMM for the inspection of wheels. The features measured are as follows.

• Radial and lateral runout of inner tire seat.
• Radial and lateral runout of outer tire seat.
• Radial and lateral runout of combined tire seats (simultaneous runout).
• Radial and lateral average runout.
• Radial delta runout.
• First to fourth radial and lateral harmonics for inner tire seat (amplitude and angle).
• First to fourth radial and lateral harmonics for outer tire seat (amplitude and angle).
• Radial low or high spot (amplitude and angle of combined radial first harmonic).
• Radial diameter and circumference of the inner tire seat.
• Radial diameter and circumference of the outer tire seat.
• Lateral width.
• Lateral offset (ET).
• Bolt hole depth.
• Bolt Hole positional tolerance.
• Bolt Hole PCD (Pitch circle diameter).
• Bolt Hole PCD concentricity (Cartesian and polar) .
• Center bore diameter with temperature compensation.
• Inner flange thickness.
• Outer flange thickness.
• The above is possible within 60 seconds.

Click here to download PDF document with more information.
You may download the free Adobe PDF reader here